#AudiotentTip 84. Multiband compressor on bass.
People tend to use multi-band compression with all the bands enabled. However that’s not always necessary. The best example being the bass.
Try using just one band on the lowest/sub frequencies to even them out and get them under control, while leaving the rest of the signal unaffected.
People tend to use multi-band compression with all the bands enabled. However that’s not always necessary. The best example being the bass.
Try using just one band on the lowest/sub frequencies to even them out and get them under control, while leaving the rest of the signal unaffected.
Leave a comment
This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.